12/27/2023 0 Comments Ils vs localizerValidity of ILS GuidanceĪn ILS is only valid if used within strict boundaries either side of the transmitted LOC and GS beams as documented on the corresponding AIPs Instrument Approach Procedure (IAP). If only the LOC is transmitting then it can only support a Non-Precision Approach with increased minima, albeit this should be a lower minima than an equivalent VOR would enable. It is very important to note that only a full ILS with LOC and GS signals is a precision approach. These checks only validate that the ILS is performing as intended and do not routinely investigate the indications which aircraft would receive if flown beyond signal validity. The reliability of this monitoring function is increased where approaches to minima lower than Category I are permitted and all ILS systems are subject to regular calibration flights to check that signals are being correctly transmitted. The transmission of ILS signals is continuously monitored for signal integrity and an installation is automatically switched off leading to the immediate display of inoperative flags on aircraft ILS displays selected to the corresponding frequency if any anomaly is detected. Reliability requirements for Category II and III ILS include a secondary electrical power supply which should be fully independent of the primary one. An example of the latter is the designation of runway holding points displaced further back from the runway so as to ensure that aircraft on the ground do not interfere with signal propagation. In the latter case, both function, reliability and operating procedures are involved. The special conditions which apply for Category II and III ILS operation cover aircraft equipment pilot training and the airfield installations. This Category is not currently available routinely primarily because of problems which arise with ground manoeuvring after landing. Category IIIC is a full auto-land with roll out guidance along the runway centreline and no DH or RVR limitations apply.Category IIIB permits a DH below 50 ft and an RVR not less than 50 m.Category IIIA permits a DH below 100 ft and an RVR not below 200 m.Category II permits a DH of not lower than 100 ft and an RVR not less than 300 m. Special categories of ILS approach are defined which allow suitably qualified pilots flying suitably equipped aircraft to suitably equipped runways using appropriately qualified ILS systems to continue an ILS approach without acquiring visual reference to a lower DH than the Category I standard of 200 feet above runway threshold elevation (arte) and do so when a lower reported RVR than the 550 metres usually associated with Category I: At the DH, the approach may only be continued if the specified visual reference is available, otherwise, a go-around must be flown. When an approach is flown, the pilot follows the ILS guidance until the decision height (DH) is reached. Typically, the first marker beacon (the Outer Marker) would be located about 5 NM from touch-down while the second marker beacon (the Middle Marker) would be located about 1 NM from touch-down.Īn approach may not normally be continued unless the runway visual range (RVR) is above the specified minimum. If marker beacons are provided, they will be located on the ILS approach track at notified distances from touch-down (see Figure 2). The usual GS angle is 3 degrees but exceptions may occur, usually to meet particular approach constraints such as terrain or noise abatement. The GS aerials are usually located so that the glide-slope provides a runway threshold crossing height of about 50 ft. Aircraft equipment indicates the displacement of the aircraft above or below the GS. The ILS GS aerials are normally located on the aerodrome they transmit two narrow intersecting beams, one slightly below the required vertical profile and the other slightly above it which, where they intersect, define the "on GS" indication (see Figure 2).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |